Guangdong Juyao Intelligent Technology Co., Ltd. · Laser Software & Process R&D
23°07′N 113°15′E · GUANGZHOU · PURE STATIC MONOGRAPH
← Back to news
Research Watch2026.10.22· 3 min read

Research Watch: Technion steers electron flow in an STM with sculpted two-colour laser fields — current bursts last just 860 attoseconds

Seeing a single atom is not hard; the hard part is “seeing the electron at the instant it moves”. The Technion team has threaded an ultrafast laser into the tip gap of a scanning tunnelling microscope and now uses the shape of the light wave itself to direct electrons — left or right depends on the attosecond offset between two light pulses.

Technion experimental schematic: two-colour infrared laser pulses strike the STM needle from the left, with a green electron current flowing in the tip–sample gap
COVERImage source: Technion – Israel Institute of Technology (official news-release illustration).
EXECUTIVE SUMMARY

On 22 October, the Technion – Israel Institute of Technology announced that Prof. Michael Krüger’s physics team has achieved precise directional control of electron flow inside the nanoscale gap of a scanning tunnelling microscope (STM) using carefully sculpted infrared laser pulses. Comparing measurements with models, the team reconstructed current bursts lasting just 860 attoseconds, while retaining about 2 nanometres of lateral resolution and sub-ångström height sensitivity — at room temperature and in air. The key: two colours of femtosecond infrared light are focused into the tunnelling gap between the tip and the sample; changing the relative timing of the two colours reshapes the optical waveform, steering electrons from tip to sample or back. Instead of repeatedly switching the laser on and off, the team varied the timing, separating the true ultrafast current from laser-heating noise. The work appears in Nature Photonics (nature.com article s41566-026-02021-y), a step toward an atomic-scale spatiotemporal microscope that can watch electrons move and locate them at once; Krüger sees it as a possible reference for future lightwave-driven electronics.

01 / Two colours set the direction: tune timing, not on/off

The apparatus is a scanning tunnelling microscope with an exceptionally sharp tip: with the tip close to the sample surface, electrons cross the gap by quantum tunnelling, and the resulting current maps nanometre-scale surface features — a mature imaging principle. The hard part is “tracking” the electrons’ rapid motion inside the gap. The Krüger team directed infrared laser pulses into the gap, each pulse containing two colours of light: changing their relative timing reshapes the optical waveform, driving electrons from tip to sample or back.

One solid experimental detail: instead of the old trick of switching the laser on and off to check the signal, the team varied the timing. That separates the true ultrafast current from noise caused by laser heating — Dr Adi Goldner says they tested three different laser systems and rebuilt the optical setup many times before signal and noise were cleanly separated. Anyone who has done ultrafast experiments knows what that sentence is worth.

02 / 860 attoseconds: three steps inside one optical cycle

Comparing measurements against several theoretical models, the team reconstructed a current-burst duration of 860 attoseconds (less than one femtosecond). The physical picture: the optical field changes so fast that the electron cannot follow adiabatically — the field launches the electron into the barrier, the wavepacket crosses the gap while the field keeps evolving, and the electron is collected on the far side, all compressed into a fraction of one optical cycle. Theoretical physicist Andrei Borisov (CNRS Université Paris-Saclay / DIPC) contributed the modelling: a single-electron strong-field picture and time-dependent density-functional theory told a consistent story.

Crucially, resolution was not sacrificed: the microscope kept about 2 nanometres of lateral resolution with sub-ångström height sensitivity — at room temperature and in air, with no cryogenic-vacuum “cheat”. That is the ambition of the work: put lightwave electronics (where the optical carrier wave, not electronic switches, sets current timing, at petahertz scales) inside a microscope that can locate things atom by atom.

03 / Next: watch electrons move at specific sites

Per Krüger, the current result is “precise control of electron flow in the nanoscale gap”; the next step is truly watching: what happens when electrons move at specific sites in a material — a single molecule, a defect. Applications remain future work — he suggests it could inform future electronics where light waves control currents, at speeds and scales beyond today’s devices.

The signal for the laser industry is direct: two-colour waveform shaping plus a tunnelling junction is a route to packing attosecond time resolution and atomic spatial resolution into one instrument. Funding came from the ERC ATTIDA project, the Israel Science Foundation (1504/20) and the Technion’s Helen Diller Quantum Center. Students Daniel Davidovich and Boyang Ma drove the experiments; Krüger recalls the day they walked into his office with the new measurement — “we could finally prove without any doubt that we can control the direction of the current.”

PRIMARY REFERENCES & LINKS

  • Technion official news: Sculpted Light Steers Ultrafast Electron Flow in an Atomic-Scale Microscope
    technion.ac.il, published 2026-10-22; university news release

    Compiled from the university news release; the paper appears in subscription journal Nature Photonics

    Open source link ↗